![]() ![]() #Hilti anchors homedepot driver#using a torque wrench, driver drill or cordless 1/4" impact driver with a maximum permitted torque rating of 100 ft. ![]() Models THD37134H and THD37212H do not meet minimum embedment depth requirements for strength design and require maximum installation torque of 25 ft. Not for use in other corrosive or outdoor environments. Intended for some pressure-treated wood sill plate applications. Mechanical galvanizing meets ASTM B695, Class 65, Type 1. Larger holes are not required for wood or thinner cold-formed steel members. Suggested fixture hole sizes are for structural steel thicker than 12 gauge only. Tighten the anchor into the base material until the hex-washer head contacts the fixture.Insert the anchor through the fixture and into the hole. ![]() (Overhead installations need not be blown clean.) Alternatively, drill the hole deep enough to accommodate embedment depth and the dust from drilling and tapping. Drill the hole to the specified embedment depth plus minimum hole depth overdrill (see table below) to allow the thread tapping dust to settle, and blow it clean using compressed air. As always you can contact my group for further details if you customer is needing this option. We have 2 Li-ion Chargers that we do stock 230 volt in. They can take anywhere from 6-10 weeks plus transit time coming from Europe.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |